Skip to content

Freesurface Model.

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › Freesurface Model.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 16, 2024 at 8:41 pm #9102
    Dip
    Participant

    Anyone worked with solid in freesurface model? There’s not enough explanation there. I’m stuck with it.Any examples or suggestions is appreciated.
    -Thanks in advance.

    August 16, 2024 at 8:44 pm #9103
    Adrian
    Keymaster

    Do you mean fixed solids? If so you can use the standard (no) slip boundaries.

    If you mean movable solids there is no existing example for that but it should be possible to couple the resolved particle code with some additional work.

    August 16, 2024 at 8:50 pm #9104
    Dip
    Participant

    Thanks, my target is to fixed solid but water is flowing surrounding it.

    August 19, 2024 at 9:18 am #9111
    Adrian
    Keymaster

    Ok, good. Then you can just adapt the boundary geometry setup in any of the existing free surface examples.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.