Skip to content

aminiyasser

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 29, 2015 at 6:23 pm in reply to: Why pressure is not calculated correctly #2254
    aminiyasser
    Member

    the problem is solved usingrnrn- Bouzidi,rnrn- localBc for the velocity and interpBc for the outflow

    September 20, 2015 at 6:46 pm in reply to: start Run from previous result #2249
    aminiyasser
    Member

    thanks so much for your replay. rncan you give me some tutorials.rnrnBest RegardsrnAmini

    September 20, 2015 at 6:42 pm in reply to: Why pressure is not calculated correctly #2248
    aminiyasser
    Member

    please send me your email. I send these figure to your emailrnthe dimension of my case is different to that paper.rnI have simulated by OpenFoam and FLUENT. they give the same results.rnrnBest Regardsrn

    September 19, 2015 at 11:28 am in reply to: Why pressure is not calculated correctly #2245
    aminiyasser
    Member

    Dear MathiasrnI have attached the comparison between the result of LBM and those of FVM for Lift, Drag rnx_velocity and pressure (at point behind the cylinder with displacement (0.2, 0.05) relative to cylinder center)rnas you can see the pressure and Drag of LBM are not similar with those of FVMrn[img][/img][img][/img]

    September 18, 2015 at 7:47 pm in reply to: Create ofstream for parallel run #2244
    aminiyasser
    Member

    Dear Mathiasrnthanks so muchrnIt is working correctly.rnrnBest Regardsrn

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)