Re: Aorta3D application

Hi Mathias, rnrnThank you very much for your reminder. I tried to adjust the surface by 3DSlicer but i failed to make very accurate “”pressure boundary parallel to the coordinate system””. Would you suggest any software for this?rnrnBesides, I want to learn more on how the aorta3D was validated by FEM and FVM. I tried to validate it in ANSYS CFX but it requires sinusoidal velocity profile of the surface. Did you use ANSYS CFX to validate the aorta3d output result? rnrnThank you.rnrnYours sincerely,rnIvy