Reply To: Truck Simulation – Boundary Conditions
OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › Truck Simulation – Boundary Conditions › Reply To: Truck Simulation – Boundary Conditions
October 25, 2020 at 5:05 pm
#5248
TamasBalogh
Participant
Hello Max!
Thank you for your suggestions! I’ve noticed that the UnitConverter has to be manually set to adapt the Mach Number (this is very counter-intuitive, as with all the input data it should be defined exactly.)
I will experiment a bit further with my setup.
Thanks again,
Tamas