Reply To: Problem with Renaming Geometry from STL File
OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › Problem with Renaming Geometry from STL File › Reply To: Problem with Renaming Geometry from STL File
April 14, 2022 at 10:47 am
#6427
jjessberger
Participant
Hi,
this is not a general solution, but merely some ideas in order to eliminate the error source (probably you have tried some of these already):
– does the problem depend on the number of cuboids/ cores?
– plot and check the material numbers in paraview, before and after each rename
– increasing the extent of the CuboidGeometry can avoid round-off errors at that stage
Yours,
Julius