Skip to content

Reply To: Modifying Parameters

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › Modifying Parameters › Reply To: Modifying Parameters

September 16, 2022 at 1:41 pm #6804
Jijo
Participant

Dear Jan,

Thank you for your replies. I really appreciate your help. I ran the original code without any modifications.

https://ibb.co/cbyD9hR

The link above is a snapshot from paraview. As marked by the red circle, Tcold boundary conditions is only applied at the corner rather than the whole right wall. If I ran the squarecavity3d example the outcome is quite different. as shown in the link below.

https://ibb.co/mqx2g2G

Which is correct according to the literature.