Skip to content

Reply To: Could not addVelocityBoundary

#6890
Fany
Participant

Dear wf_guoyl,

Your code seemed to simulate single component multiphase flow. I am simulating the flow boiling based on Julius Weinmiller’s work. But it always had a problem of “density is NAN”(“uMax=0.523235; avEnergy=-nan; avRho=nan”). I found uMax sharply increased from 0.007 to 0.53 after the endTimeInit. Have you encounterred this problem?
I would like to ask how you set the MaxVelocity. should it be same with the inlet velocity? I appreciate very much if you can share you code to me.

Best regards,
Fany