Skip to content

Reply To: About the distance between the boundary node and stl in “setBouzidiBoundary”

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › About the distance between the boundary node and stl in “setBouzidiBoundary” › Reply To: About the distance between the boundary node and stl in “setBouzidiBoundary”

December 5, 2023 at 4:04 pm #7983
Yuji
Participant

Thank you for your reply.

How did you mark the interior of the STL file in the material geometry?
>> I did same cpp file in example/cylinder3d because I used it.

Just to be sure: Did you take into consideration that the Bouzidi boundary distances are computed in lattice units while the distance you see in Paraview is in physical units?
>> Yes I did.