Re: How to set a slip boundary.
OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › How to set a slip boundary. › Re: How to set a slip boundary.
May 25, 2016 at 6:40 am
#2371
Benxi
Member
Quote:
Quote from robin.trunk on May 23, 2016, 08:39rnHi,rnrnI think this could be the same problem discussed in the topic “”Question about Cavity2d Example”” recently started by frankgao. Probably the points where the boundary can’t be set happen to be on the overlap?rnrnBest regardsrnRobin
rnrnrnThank you! I will go for a watch.