Skip to content

Re: Pressure Inlet

Due to recent bot attacks we have changed the sign-up process. If you want to participate in our forum please send a message via our contact form.

› Forums › OpenLB › General Topics › Pressure Inlet › Re: Pressure Inlet

July 21, 2018 at 3:42 pm #2897
robin.trunk
Participant

Hi Laurent,

the material numbers do not specify the type of an area, but rather the area itself. This means it is
3 = boundary layer on the left
4 = boundary layer on the right
The type of boundary is defined by “addPressureBoundary” or “addVelocityBoundary” respectively.

To get a better grip on these topics you may want to visit our next Spring School in february:
http://www.openlb.net/spring-school-2019

Best
Robin