Skip to content

Reply To: porousPlate2d

Due to recent bot attacks we have chanced the sign-up process. If you want to participate in our forum, first register on this website and then send a message via our contact form.

› Forums › on OpenLB › Bug Reports › porousPlate2d › Reply To: porousPlate2d

December 19, 2023 at 10:35 am #8095
Rookie
Participant

Dear Adrian

It’s not terminated, it’s when I turn off parallelism that I get these problems, it outputs the image from step 0 and the simulation doesn’t move, it doesn’t break. Normally gnuplot itself doesn’t have problems due to serial mode. I guess it could be because of this gnuplot problem or the simulation slows down when parallelism is turned off. It could be that gnuplot is not suitable for non-parallel use in this code?

Best Regards,
Rookie