Skip to content

Re: Question about Cavity2d Example

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › Question about Cavity2d Example › Re: Question about Cavity2d Example

May 21, 2016 at 8:51 am #2360
frankgao
Member
Quote:
Quote from robin.trunk on May 19, 2016, 12:23rnHi,rnrnhow many processes did you use? It is possible that some querys fail on the overlap, but this does not affect the simulation. Do this local coordinates match the borders of your cuboids?rnrnBest regardsrnrobni

rnrnThanks for your reply. I didn’t compile the program using parallel mode. So,i think i just used one process. I didn’t check the border either. Since i didn’t change the example code, I was thinking maybe some one was caught up in the same situation.