Skip to content

about post-processing

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › about post-processing

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 19, 2020 at 4:16 am #4853
    Dylan1
    Participant

    Dear all

    In paraview I get the aorta module by using threshold. But when I choose the representation of volume, it only show the bottom volume. How can I get the whole volume?

    Best regards
    Dylan

    March 23, 2020 at 4:50 pm #4888
    fk
    Participant

    Dear Dylan,

    maybe you need to first apply the “Resample To Image” filter. This can be found in Paraview under “Filters” then “Alphabetical”.

    Best regards,
    Fabian

    March 24, 2020 at 11:00 am #4891
    Dylan1
    Participant

    Dear Fabian,

    I found it! Thanks for your advice.

    Best regards,
    Dylan

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.