Skip to content

compressible fluid

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1926
    Mamin
    Member

    Hi all,
    How to set that the fluid I’m using is compressible and I want to set up pressure value at the in and out flow boundaries. I have seen addPressureBoundary function but I wasn’t sure how to add the values.
    Thanks

    #2674
    cloner0101
    Member

    dear Mamin
    whats your model you want to simulate ?

    #2676
    Mamin
    Member

    I want to simulate a gas (helium) in a aerodynamic lens (or just a cylinder of 1 cm radius) with smaller outlet (1mm). The pressure at the inflow is 2 mbar and 0 on the outflow.
    Thank you

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.