Hello all,
well, I have a problem setting up the conjugate heat transfer for the following case.
https://imgur.com/cDc8d6B
I created the geometry, tried to implement into the code, and play a bit with it but I still get the same message about the wrong material number. I went through all posts on this forum but could not find any precise answer and methodology how to deal with such cases. I found one topic in which it was stated that it is possible to simulate CHT but I think I will need more insight and learning than just an answer in the form of one post or manual.. so if there is anyone here who would like to help me and set the whole setup, of course not for free, I would be very grateful.
Leaving email richard_hend90@yahoo.com
Best regards
-
This topic was modified 4 years, 9 months ago by richardh90.