Multiphase flow Contact angle and surface tension setting
- This topic has 1 reply, 2 voices, and was last updated 7 years, 6 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
🙂 Hi everyone, I’m using Openlb for multiphase flow simulation. I have been trying to find out how to set the contact angle and surface tension but I have not figured it out.
If someone knows how to set them in the code? thank you very much!You need to define the right density at the boundaries (defineRho or for bounce back in the constructor), i.e. 1 for attracting and 0 for repelling. Best Mathias
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.