Single Compressor Blade Simulation
- This topic has 1 reply, 2 voices, and was last updated 11 months, 1 week ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hello everyone,
I would like to know if OpenLB software is capable of running high-speed flow simulation 🙂
Currently i am simulating a single compressor blade simulation in ANSYS Fluent (mesh is generated using ANSYS ICEM) and i am thinking of replicating the same case using an opensource software.
Boundary conditions for my simulations are as below and INLET Mach number is around 0.7
INLET
Total pressure 115775 Pa
Total temperature 340.2 kelvinOUTLET
static pressure 97251 PaThank you very much for your time and looking forward to hear from anyone 🙂
No, not yet — within a project we could implement such a model.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.