Skip to content

Stl file not valid

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › Stl file not valid

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 3, 2019 at 8:15 pm #4660
    lchn1
    Participant

    Hi, every one. I’ve just convert to use openLB, so I wanna to try to compile cylider3d. But when I run it, it shows “runtime_error:STL File not valid.”
    In fact fall all three case with stl, it works as this.
    And my version is 1.3r1.
    Do anybody know how to deal with this~~~.
    Thanks a lot.

    November 4, 2019 at 8:42 am #4661
    mathias
    Keymaster

    Dear Ichn1,

    Which hardware and which operating system are you using? Have you checkted the access rights to the files?

    Best
    Mathias

    November 4, 2019 at 11:26 am #4662
    lchn1
    Participant

    Thank you for your reply, mathias.
    On your advice, I find there’s a very lowest error that I did. That I wanna to start it by double click~.
    Instead of this now I use ./name, then it works.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.