Skip to content

waterAirflatInterface2d: Inflow and Outflow

New to LBM and OpenLB? Attend our upcoming one-week hands-on Spring School in Marseille/France from 19.05.2025 – 23.05.2025.

OpenLB – Open Source Lattice Boltzmann Code › Forums › on OpenLB › General Topics › waterAirflatInterface2d: Inflow and Outflow

Viewing 1 post (of 1 total)
  • Author
    Posts
  • March 9, 2024 at 3:34 am #8388
    CWhalley_1
    Participant

    Hi all,

    I have been experimenting with the newly added waterAirInterface2d model and was wanting to try add an inflow and outflow to the system. Is there any way to do this currently as I have not had any success so far?
    I have tried using setInterpolatedVelocityBoundary for the inlet and setInterpolatedPressureBoundary at the outlet however this did not work.

    Any suggestions on the appropriate inlet and outlet types would be greatly appreciated.

    Kind Regards,

    Callum

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.