[iJokerify]

Hi Max,

thanks for your reply. I should deal with the parameters a bit.

Grateful,
Sergey

[iJokerify]

70 euro is little bit less than I can afford…)
BTW, thank you!

[iJokerify]

I set this values at random, using the dependency seen in the examples like:
dt has to be less, when dx.

The velocity in real test has to be 0.05 to 0.5 m/s.
The maximum simulation time is 2 seconds.

Thanks for your help!

• This reply was modified 3 years, 11 months ago by iJokerify.

[iJokerify]

Dear Mathias,

thanks for your reply! I’ll try to increase resolution and if problem will not solve i’ll write then.

Grateful,
Sergey

[iJokerify]

Dear Mathias,

yes, i saw it. What could be reason for this?

Grateful,
Sergey

[iJokerify]

Dear mathias.

I still cant to solve my problem. Can i send you photo of stl model and several questions about resolution via mail? I’ll be very grateful!

Redgards,
iJoker.

[iJokerify]

when i increasing resolution, the progress is aborting “Killed” when Voxelizing. It means, there are some limit for resolution ?

• This reply was modified 3 years, 11 months ago by iJokerify.

[iJokerify]

Dear mathias,

what means the watertight? The stl haven’t holes on bounds of material ? Or exists some parameter of stl model which applying the watertight property to stl?

Grateful
iJoker

[iJokerify]

Thanks for your reply! Changing directory has no effect, but respond had no error when i tried to run example with “make” and “./cylinder3d”.
However this method do not suitable for me cause i still need the way to debug code.
I’m using CLion to debug and i can’t find the way to run MakeFile through CMake.
Please notify me if you know how to do it!

Regards
iJokerify

• This reply was modified 4 years ago by iJokerify.

[iJokerify]

Dear Mathias

I had asked the question earlier. How to compile the project with OpenLB with IDE. Then i got an advice to use CMake to link source files.
There is one more way to compile the project? Please answer how!

Sincerely
iJokerify

• This reply was modified 4 years ago by iJokerify. Reason: grammar mistake

[iJokerify]

Dear Sthavishtha

Im using CMake and there is the line inside CMakeLists that runs the code:
add_executable(Project ${SOURCE_DIR}/cylinder3d.cpp)
and the error still don’t fixed

Sincerely
iJokerify

[iJokerify]

Dear Sthavishtha

Thank you very much for your attention! I didn’t thought it has to be installed separately. Now i’ve solved this problem. Thank your again.

Sincerely
iJokerify

[iJokerify]

I’m sorry but i didn’t receive your email. Can your resend it ?

[iJokerify]

Thanks for your reply. My email is ijoker0998@gmail.com and i’ll very grateful if you send it )

[Author]

Posts